Open Theremin V3

2017-02-26T18:40:59Z

Gather:
- active/powered speakers with a 3.5mm stereo audio jack (bonus points if the power plug is grounded)
- camera tripod
- Arduino Uno, from wherever it has been gathering dust (and USB/power cable)

Acquire:
- Open Theremin Arduino Shield
- 1m of aluminium round tube; 6mm external thickness, 1mm wall thickness, 4mm internal diameter, from your local hardware shop

Do:
- Cut tube in half, and bend (or get bent) each half into the shape described in the diagram
- Solder shield together. (The button and LEDs are surface mounted. I scorched a leg pad of the yellow LED, so no blinky yellow for me.)
- Program Uno
- Plug all the bits together. The whole lot should be grounded, but both my speakers, and the Arduino, are powered over USB, and I could not find an earthed USB-converter plug. So, at the moment, they are plugged into my laptop, which is plugged into the mains. (There is a ground pad on the shield that I should hook up in future.)
- Power up, leave to warm up, trigger auto-calibration
- Make ALL THE NOISE

Theremin!
Photo by chebe

- Start band

comments

Busy hands | Disquiet mind

Open Theremin V3